Used DBX 1066 Compressor - Limiter - Gate

Γράψτε μια κριτική
300.00
DBX 1066
Σε Απόθεμα
4 Είδος(η)
+

Used DBX 1066 Compressor - Limiter - Gate

  • Input Connectors:XLR and 1/4" TRS (Pin 2 and tip hot)
  • Input Type:Electronically balanced/unbalanced, RF filtered
  • Input Impedance:Balanced > 50 kOhm, unbalanced >25 kOhm
  • Max Input:> +24 dBu balanced or unbalanced
  • CMRR:Typically >50 dB at 1 kHz
  • Output Connectors:XLR and 1/4" TRS (Pin 2 and tip hot)
  • Output Type:Servo-balanced/unbalanced, RF filtered
  • Output Impedance:Balanced 120 Ohm, unbalanced 60 Ohm
  • Max Output:> +21 dBm balanced, > +20 dBm unbalanced
  • Sidechain Input Connector:1/4" Unbalanced (Tip-Sleeve)
  • Sidechain Input Type:Unbalanced, RF filtered
  • Sidechain Impedance:>10 kOhm
  • Sidechain Max Input Level:>+24 dBu
  • Sidechain Output Connector:1/4" Balanced TRS (tip hot)
  • Sidechain Output Type:Impedance balanced, RF filtered
  • Sidechain Output Impedance:Balanced 2 kOhm, unbalanced 1 kOhm
  • Sidechain Max Output Level:>+21 dBu balanced or unbalanced
  • Bandwidth:20 Hz to 20 kHz, +0/0.5 dB
  • Frequency Response:0.35 Hz to 90 kHz, +0/-3 dB
  • Noise:< -95 dBu, unweighted, 22 kHz measurement bandwidth
  • Dynamic Range:> 118dB, unweighted
  • THD+Noise:0.008% typical at +4 dBu (1 kHz unity gain), 0.08% typical at +20 dBu (1 kHz unity gain), < 0.1% any amount of compression up to 40 dB, 1 kHz
  • IMD:< 0.1% SMPTE
  • Interchannel Crosstalk:< -80 dB 20Hz to 20 kHz
  • Stereo Coupling:True RMS Power Summing
  • Compressor Threshold Range:-40 dBu to +20 dBu
  • Compressor Ratio:1:1 to infinity:1
  • Compressor Threshold Characteristic:Selectable OverEasy® or hard knee
  • Compressor Attack/Release Characteristic:AutoDynamic™
  • Compressor Attack/Release Modes:Selectable Manual or Auto
  • Compressor Manual Attack Time:Scalable program-dependent
  • Compressor Manual Release Time:Scalable program-dependent
  • Compressor Auto Attack Time:Program-dependent
  • Compressor Auto Release Time:Program-dependent
  • Compressor Output Gain:-20 to +20 dB
  • Limiter Threshold Range:+4 dBu to +24 dBu (off)
  • Limiter Ratio:infinity:1
  • Limiter Type:PeakStopPlus® two-stage limiter
  • Limiter Stage 1:PeakStop® brickwall limiter
  • Limiter Stage 1 Attack Time:Zero
  • Limiter Stage 1 Release Time:Zero
  • Limiter Stage 2:Predictive intelligent program limiter
  • Limiter Stage 2 Attack Time:Program-dependent
  • Limiter Stage 2 Release Time:Program-dependent
  • Expander/Gate Threshold Range:Off to +15dBu
  • Expander/Gate Ratio:1:1 to 30:1
  • Expander/Gate Attack Time:< 100 µsec
  • Expander/Gate Release Time:Program-dependent
  • SC Ext. Switch:Routes the external sidechain input signal to the detector
  • SC Mon. Switch:Routes the sidechain signal to the output, interrupting the normal audio
  • OverEasy® Switch:Activates the OverEasy compression function
  • Countour Switch:Activates the frequency-dependent detector function
  • Auto Switch:Activates automatic program-dependent attack and release times, disabling the manual Attack and Release controls
  • I/O Meter Switch:Switches between monitoring input and output levels on the Input/Output Level meter
  • Bypass Switch:Activates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec.
  • Operating Level Switch:(rear panel)Switches the nominal operating level between -10 dBV and +4 dBu simultaneoulsy for both input and output levels
  • ST Link Switch:Link both channels for stereo operation. Channel One becomes the master
  • Gain Reduction Meter:12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB
  • I/O Meter:8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu
  • Compressor Threshold Meter:3-segment LED bar graph at Below (-), OverEasy and Above (+)
  • Expander/Gate Threshold Meter:2-segment LED bar graph at Below (-) and Above (+)
  • Limiter Threshold Meter:1 LED to indicate PeakStopPlus™ limiting
  • Function Switches:LED indicator for each front-panel switch
  • Output Transformer Options:Jensen® JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx
  • Operating Voltage:100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz
  • Power Consumption:20 Watts

Δε βρέθηκαν Κριτικές